Chicken Netting Wire Netting

SKU: N/A Category: Wire Netting

These products can be collected from us, sent by carrier to you or delivered by us in the local area as part of a larger order

Fence posts Plant Stakes Round & half Round

Fence Posts, Stock Fence

We have a range of the finest quality slow grown Scandinavian timber fence posts / fence stakes. They are suitable for a variety of uses on the farm, small holding or garden. In addition to our range of round fence posts we also stock rectangular and square sections. The rectangular come in flat or pointed versions.

£2.30 – £15.15

Select options

Stock Fence

Stock Fence, Wire & Mesh

£71.66 – £270.20

Stock Fence

Stock Fence, Wire & Mesh

no-sidebars

£71.66 – £270.20

Select options

Wood Fence Posts & Gate Posts

Fence Panels & Gates, Fence Posts, Gates

£6.95 – £69.95

Wood Fence Posts & Gate Posts

Fence Panels & Gates, Fence Posts, Gates

£6.95 – £69.95

Chicken Netting Wire Netting in 50m rolls from Suffolk Farm Fencing. Various heights and hole sizes are available, the wire thickness is 19G.

The traditional chicken wire has 50mm (2″) holes and as it says is good for chicken and larger bird runs. If you need something smaller we have a 25mm (1″) hole size which is much stronger than the 50mm version. Both of these sizes are available in different heights.

Rabbit Fencing

If you are looking for Rabbit Fencing then we also stock the 31mm hole size which comes in 105cm wide rolls.

Posts

Buying Rabbit fencing to fit to existing fencing, then support posts will not be needed. If you are going to erect the rabbit netting as a stand alone fence then this will need timber fencing stakes driven into the ground at about 4-5m centres. Larger diameter straining posts are required at ends and changes of direction, these will need to be complete with struts.

Lapped or buried?

There are two methods that you can use to make sure rabbits do not get under the fence. These are either to fold over at least 150mm of rabbit netting at ground level on the side of the fence where the rabbits are known to come from, or digging a trench 300mm deep and burying the netting into the trench.

Support Wires and Netting Clips

Wire netting cannot be strained so it must be fixed to a support wire or wires. Use a 2mm plain wire to support the netting. The netting is normally clipped to the support wire every 300mm using netting clips. If the netting is buried only one support wire is required, located at the top of the netting. If the netting is folded at the base another support wire will be required just above ground level.

Roll Sizes and Wire Gauges

Available in 50m rolls in heights of 1050m. Physical damage to your rabbit wire netting fence is a real and ever present danger. This can occur from mowers and strimmers, other wildlife (particularly badgers) can also make holes in the netting.

A Video on installation

is viewable here